Load Cells and Force Transducers

KA Sensors supply a wide range of Load Cells for applications including:

  • Gearshift
  • Suspension
  • Steering
  • Pedal Force
  • General Testing

Contact us to discuss your application..

GSS In-Line Gearshift / Flatshift Load Cell / Sensor
GSS In-Line Gearshift / Flatshift Load Cell / Sensor

The GSS series of miniature load cells are fitted into the gearbox control rod and designed for use in clutchless gearshift applications. During the gearchange sequence the driver moves the gear lever as normal, the GSS series load cell detects the force applied to the gear shift lever, this force is measured by the ECU, then a series of control events take place that allows the gears to mesh with full throttle still applied.

Typical application include: Gearshift - Suspension - Steering - Pedal Force - General Testing

  • Miniature Size
  • ±500N or ±1000N Range
  • Ruggedised Construction
  • 5V or 8-16V Supply
  • M6 or M8 threads Standard
  • ±1% Accuracy
GST Gear Lever Load Cell /Sensor
GST Gear Lever Load Cell /Sensor

The GST Series Gear Lever Load Cells are designed for the detection and measurement of tension/compression forces in gear shift applications. Installed directly on top of the gear lever, the load cell is fitted with an aluminium or nylon knob. Detection of the direct driver input force is made when selecting gears. The load cell has a pre amplified signal which is compatible with most ECUs, therefore ensuring a simple and reliable clutchless gear change strategy to be performed.

Typical applications include: Gear Shift - General Testing

  • For Sequential or ‘H’ Pattern Gearbox
  • ±250N, ±500N or ±1000N Range
  • Rugged Construction
  • 5V or 8-16V Supply
  • Built-in Amplifier
  • ±0.5% Accuracy
SGF Strain Gauge - Force
Strain Gauge - Force

KA Sensors are experts at the very precise application and calibration of strain gauges to key components.    This is a bespoke service and typically applied to suspension push/pull rods (Force) and also drive/prop shafts and steering columns (Twisting/Torque).  See separate datasheets for Strain Gauge Force and Strain Gauge Torque below.

Typical applications include: Suspension Components: Pull & Push Rods - Rod Ends

  • ±10 to ±30 KN
  • ±1000 to ±3000 Kilogram Force
  • Amplified Output
  • 5V or 8-16V Supply
  • Full Custom Service